Re: HTTP BAD Request

[Scott Klement <sk@xxxxxxxxxxxxxxxx>]

hi Donald,

There's instructions on how to create a debug log on the 2nd half of the 
following page:
http://www.scottklement.com/httpapi/beta/

The most common cause of a "bad request" would be an invalid character 
(such as a blank) in your URI.  (Though, there are other causes as well.)

Your e-mail disclaimer scares me.  Please understand that this is a 
public mailing list, anything posted here is published to any interested 
party on the Internet (including a public web archive.)  This conflicts 
with the legal disclaimer on your e-mails, which state that the 
information in the e-mail can't be shared.  Please remove that 
disclaimer in future posts.



On 3/2/2010 7:58 AM, Zimmerman, Donald W. wrote:
>
>     I am receiving a bad request and I have looked at the XML up and down
>     and see nothing wrong. I am unsure how to display the debug statements
>     as I see in many other questions. Can someone easily tell me how this
>     is accomplished?
>
>     Notice: THIS DOCUMENT MAY CONTAIN CONFIDENTIAL OR PROPRIETARY
>     INFORMATION, INCLUDING PATIENT HEALTH INFORMATION THAT IS PROTECTED
>     UNDER HIPAA AND OTHER STATE AND FEDERAL CONFIDENTIALITY LAWS. PLEASE
>     DELIVER IMMEDIATELY ONLY TO THE INTENDED RECIPIENT. IF THIS
>     TRANSMISSION WAS RECEIVED IN ERROR, PLEASE CONTACT THE SENDER
>     IMMEDIATELY AND DO NOT DISTRIBUTE THE INFORMATION TO ANY OTHER PERSON.
-----------------------------------------------------------------------
This is the FTPAPI mailing list.  To unsubscribe, please go to:
http://www.scottklement.com/mailman/listinfo/ftpapi
-----------------------------------------------------------------------